4/8/2023 0 Comments Structorizer always in frencharrz) with an optionally appended sequence of diagram names or routine signatures, separated with exclamation marks (no blanks!), e.g.ĭ:\workspace\kay\tests\bar.arr!MAIN!sub(2-3)!test(7) An arrangement file specification consists of an arrangement file path (.arr. Since version 3.29-05, it might also be a so called Arrangement file specification. arrz) to be converted into a source file. Nsdarr-file is the file path of a Structorizer diagram (.nsd) or an arrangement file (.arr or. explicit switches have priority over file-based settings, also see below). L would switch off the line numbering even if a specified settings-file specifies otherwise, i.e. the binary ones), the respective upper-case letter has the exactly opposite effect (e.g. ![]() If -o option is also given, then the result will be written both to standard output and to the specified output file.įor some of the above options (i.e. (single minus sign) will direct the code to the standard output instead of to the default output file. (Usually, you will adhere to the export settings held in structorizer.ini, though, which is maintained via the Structorizer Export Options dialog). Of course you can modify the values with a text editor in the selectively saved ini file without changing your settings residing in structorizer.ini. So you won't any longer have to look for the relevant keys among the randomly ordered key-value pairs in the abundant structorizer.ini file like for a needle in a haystack and then copy the strewn lines to your import settings file. Since version 3.29-12, you may configure export options in Structorizer GUI and save just these export options to a specific ini file, see Preferences export and import. (Without switch -s the application defaults would be used.) The file must contain relevant key=value pairs, where the keys for generator-specific options are composed of the generator name and a corresponding export option name, both glued with a dot, whereas general export option keys start with "genExport", e.g.: ![]() s (followed by a text file path) specifies a settings-file to be used used for retrieval of general and generator-specific options for the export. If several nsd files are given then without option -o the created file will be named after the first nsd file name with option -o, however, the filename of the option will be used. The target-language-specific file name extension is ensured in either case. If not given then the output file name will be derived from the first nsd (or arrz) file name by replacing the file name extension with the one associated to the target language, e.g. o (followed by a file path or name) specifies a non-default output file name. Whereas a "C" export will result in the code: If you then do a "Pascal" export, the generated code will be: ":Īll the words you filled in there will be filtered out and replaced by the respective target language keywords.įor example, if your diagram contains a FOR loop and you are writing french diagrams, you may have something like this: ![]() You can find them via the menu " Preferences › Parser. First of all, if you want to use the code generators, you should make sure to have filled in the parser preferences appropriately.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |